|
|
|
 Fear the power of the custodians! - Fixen [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Fear the power of the custodians! - Fixen [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
20-12-2008, 13:51
|
||||
|
||||
|
Re: cRIO interrupted during reimaging
After the IP Reset, I still get a continous blinking status light.
The ethernet port on the cRIO shows a green light on the 10V/100 side, and a solid orange light on the link side. Both MAX and the Imaging Tool are unable to find the cRIO. We are linked to the DS throught ETH2 all lights are green, which is linked to the cRIO through ETH1 with a green light on the DS and the lights on the cRIO described above. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO plugin problem | gabrielse | National Instruments LabVIEW and Data Acquisition | 3 | 18-12-2008 11:30 |
| HELP reimaging | RMS11 | Control System | 4 | 17-12-2008 21:21 |
| updating firmware on crio | nickmagus | Programming | 16 | 17-12-2008 16:58 |
| crio update file | nickmagus | Programming | 1 | 28-11-2008 19:20 |
Threaded Mode