|
|
|
 Let's see some love for these fine people. Let's give it up for the refs. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Let's see some love for these fine people. Let's give it up for the refs. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Hex Shaft Wear Experiences
I believe some of the issues that occur with the Toughbox and other mass produced hex shaft mechanisms, is the fact that they are mass produced. There is a tolerance in which the parts are made, some will be further from perfect then others.
|
|
#2
26-12-2008, 18:02
|
||||
|
||||
|
Re: Hex Shaft Wear Experiences
We used live axles with cantelevered wheels last year using 1/2" hex aluminum. It worked out very well. The wheels were AMs with hex bore and some omni's with the hex adapter. The sprockets on the wheel axles were nylon and the problems we had with wear was on the sprocket teeth due to inadequate tension in the chain. We had no wear in the hex parts at all.
http://www.vandenrobotics.com/plogge...picture&id=653 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engineers! Please share you experiences!!! | Liz C | Career | 13 | 21-02-2008 17:11 |
| Combustion compression experiences? | rastermon | 3D Animation and Competition | 3 | 14-02-2008 15:41 |
| Experiences at BattleCry 6 | akshar | Off-Season Events | 7 | 26-06-2005 17:31 |
| Securing hex shaft to drill output | D. Gregory | Technical Discussion | 6 | 24-01-2003 14:05 |
| Experiences with Belting | Patrick Wang | Technical Discussion | 15 | 26-09-2002 20:26 |
Hybrid Mode
