|
|
|
 Do I think the bar is too high? I think impossible dreams and lofty goals are a key part of FIRST; the "top" being extremely far away only pushes people farther. - Chris is me [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Help with updating firmware on Driver Station
Our team followed the firmware update procedure for the Driver Station correctly but for some some strange reason the Driver Station stayed in flashing mode (ie the screen where it says "DO NOT SHUT OFF!") for close to two hours. The instructions say that it takes about 3 mins to flash. We eventually had no choice but to cycle power on the device because it was obvious that something went wrong. Now the Driver Station looks like it tries to boot up but gets locked up with the "Kwik Byte" image on the screen.
Any ideas on how we could possibly bring it back to life? Thanks for any help! 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver Station Help.. | 1708xMr.Roboto | FRC Control System | 8 | 22-12-2008 15:24 |
| Driver Station Setup?? | Team 1708 Dave | Programming | 9 | 19-12-2008 23:09 |
| updating firmware on crio | nickmagus | Programming | 16 | 17-12-2008 16:58 |
| Trouble updating firmware | AdamHeard | FRC Control System | 4 | 17-12-2008 09:22 |
| Help with driver selection | LBK Rules | General Forum | 28 | 04-02-2003 18:04 |
Threaded Mode