|
|
|
 A clean pit is a happy pit, a clean pit is a controlled pit, a clean pit is a safe pit. - DjAlamose [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A clean pit is a happy pit, a clean pit is a controlled pit, a clean pit is a safe pit. - DjAlamose [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
31-12-2008, 00:27
|
||||
|
||||
|
Re: Analog inputs not "working" — I only detect "noise"
Plugging in a 9 volt battery to one of the inputs was probably a very bad idea. The inputs are supposed to read voltages from 0 to 5 volts, and it is possible that you damaged ether the Analog Breakout Board, the Analog cRIO module, or both. I don't know, but it is possible that only the one input you were using was damaged and the rest of the inputs are still good. I would try it again with a 0 to 5 volt signal on a different input. If that doesn't work, then try a different module with a different breakout board.
Edit: This information is wrong. The input range is -10 to 10 volts. You cannot have done any harm with your 9 volt battery. Last edited by Kitmor : 31-12-2008 at 00:49. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Championship Event - Where the "Random" Match Sorting Really "Shines" | Travis Hoffman | Championship Event | 57 | 19-04-2007 08:06 |
| Congratulations is spelled with a "T" and not a "D"!! | Elgin Clock | Thanks and/or Congrats | 55 | 09-03-2007 13:24 |
| New NEMO White Papers! "Creating a Killer Packet" and "25 Ways to Sponsor" | Jessica Boucher | Team Organization | 0 | 10-08-2005 10:55 |
| Exempli Gratia: "Jason Morrella" not "Jason Morella" | Bill Gold | CD Forum Support | 8 | 10-10-2004 19:01 |
| "Thunderbirds" Vs. "Team America" Which one will rule the box office? | Elgin Clock | Chit-Chat | 3 | 07-09-2004 19:53 |
Threaded Mode