Wiring analog breakout?

excel2474 · #1 31-12-2008, 15:46

I'm not quite sure how to power the analog breakout. Thanks for the help.

Jason Law · #2 31-12-2008, 16:40

Quote:

Originally Posted by excel2474

I'm not quite sure how to power the analog breakout. Thanks for the help.

You can read Chapter 3 (pg. 20 - 26) of the 2009 Control System documentation on FIRST's website (found here)

More specifically, you can find out how to pass power to the analog breakout on page 24 of Chapter 3.

Hope this helps,

Jason Law

excel2474 · #3 31-12-2008, 16:41

Ok thanks I'll check that out.

excel2474 · #4 31-12-2008, 17:14

Where does the analog breakout get plugged into the distribution block.

Jason Law · #5 31-12-2008, 17:20

Quote:

Originally Posted by excel2474

Where does the analog breakout get plugged into the distribution block.

If you look at the power distribution diagram (found here), you will find that the analog breakout is connected to the 30A connectors on the power distribution board.

Hope this helped,

Jason Law

excel2474 · #6 31-12-2008, 17:30

Ok, thanks for the help.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pneumatic breakout question.	IndySam	FRC Control System	5	23-12-2008 17:10
5 Amp Fuses for Analog Breakout & Solenoid Breakout	finman	Electrical	3	10-12-2008 11:59
Help wiring potentiometer-to-Analog port	kylehager	Electrical	4	17-01-2008 17:28