|
|
|
 All labor is donated by the webmaster "Brandon". - Mike Martus [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| All labor is donated by the webmaster "Brandon". - Mike Martus [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
ETH 1 Port on Driver Station
Has anyone had any complications with the ethernet ports on the Driver Station?
I was loading code, from Labview, to the robot. The laptop was connected to the Eth 1 port and the Eth 2 port connected to the bridge. Labview quit at around 50% and displayed an error message "Peer has disabled communications. Please retry." (Not exact error message) The LED on the DS next to ETH 1 went out after this point. Further attempts to load code were met with "Can not locate the Real-Time client", even after switching to different cables and computers. If anyone has any experience or advice, it would be greatly appreciated. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driver Station Help.. | 1708xMr.Roboto | FRC Control System | 8 | 22-12-2008 15:24 |
| Driver Station Setup?? | Team 1708 Dave | Programming | 9 | 19-12-2008 23:09 |
| Mounting the Driver Station...? | 1708xMr.Roboto | FRC Control System | 1 | 15-12-2008 12:34 |
| 2009 Driver Station Dimensions | noxryan | FRC Control System | 5 | 27-11-2008 21:02 |
| size of driver playing station | 663.keith | Technical Discussion | 1 | 11-01-2005 13:23 |
Threaded Mode