|
|
|
 Only think of Gracious Professionalism as a standard to work toward personally. Never use it as a gauge to point out someone else’s shortcomings.
- Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Only think of Gracious Professionalism as a standard to work toward personally. Never use it as a gauge to point out someone else’s shortcomings.
- Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
03-01-2009, 18:01
|
||||
|
||||
|
Re: Source for Vision Target Fabric
The camera can track any number of targets (well, there's probably a limit, but I doubt that'd be realistic), but it all depends on the software that uses the camera. Sure, the camera may appear to track one target, but most likely it is choosing one specific target particle due to its qualities.
If you're going to play with vision, go play in Vision Assistant. You can then export from there a LabView VI, which you can use on the robot. Cheers -Tanner 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Durability of Vision Target | geeknerd99 | General Forum | 13 | 11-02-2006 14:15 |
| Vision Target Assembly | platt | Kit & Additional Hardware | 4 | 26-01-2006 17:34 |
| Question concerning vision target | Otrobotics | General Forum | 17 | 15-01-2006 15:59 |
| vision target | Dakota Snow | Kit & Additional Hardware | 1 | 08-01-2006 23:00 |
Threaded Mode