New wheels / floor and encoders for position.

#21

04-01-2009, 12:51

BlackBird11891 BlackBird11891 is offline

We Rise Above Our Challenges

AKA: Chad Krivanec

FRC #1927 (Team Tempest)

Team Role: Engineer

Join Date: Jan 2008

Rookie Year: 2005

Location: Biloxi

Posts: 34

BlackBird11891 is on a distinguished road

Re: New wheels / floor and encoders for position.

you could just use a kit wheel and make it pivot that way your not breaking any rules because its not being powered it would not slip so the encoder would know where it was

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
4 encoders + mecanum wheels programing	Smoking_Gun	Programming	4	18-01-2007 23:43
Friction coefficients for Omni wheels and Mecanum wheels from AndyMark	Andy Baker	Technical Discussion	11	16-12-2006 19:40
Testing and Cause of Failure for Encoders and Hall Effect sensors	ChrisH	Electrical	28	19-09-2005 01:07
I think its time for some new wheels	Matt Reiland	Rules/Strategy	1	24-03-2002 19:02

All times are GMT -5. The time now is 05:46.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.