|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#25
|
|||
|
|||
|
Re: New wheels / floor and encoders for position.
The hard part of using the mouse is interfacing to it. The new controller doesn't have any USB inputs on the Robot side, so you would either have to add a microcontroller or learn the PS/2 standard.
Alternatively, you can poke directly into the chip inside the mouse. There is no guarantee that this is a standard protocol - each vendor can use their own. This is the route we chose. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4 encoders + mecanum wheels programing | Smoking_Gun | Programming | 4 | 18-01-2007 23:43 |
| Friction coefficients for Omni wheels and Mecanum wheels from AndyMark | Andy Baker | Technical Discussion | 11 | 16-12-2006 19:40 |
| Testing and Cause of Failure for Encoders and Hall Effect sensors | ChrisH | Electrical | 28 | 19-09-2005 01:07 |
| I think its time for some new wheels | Matt Reiland | Rules/Strategy | 1 | 24-03-2002 19:02 |