|
|
|
 I believe in my students, I encourage them to fail in their endeavors to find the best formula. There is valuation in failure. - Chief Hedgehog [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I believe in my students, I encourage them to fail in their endeavors to find the best formula. There is valuation in failure. - Chief Hedgehog [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Working with spikes and servos in labview
Hello all the programming team and I are still getting used to this new labview environment and we can successfully get the 2.5 inch CIM motors to drive using jaguars but we would like to be able to assign a button to activate a spike controlling a servo. what must we do in lab view to get this to work or is it not even possible.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C and LabView version control with Git | Nibbles | NI LabVIEW | 31 | 17-01-2010 19:22 |
| Labview Servos | quizbiz | NI LabVIEW | 5 | 09-01-2009 08:48 |
| Labview NXT Servos | quizbiz | National Instruments LabVIEW and Data Acquisition | 1 | 30-12-2008 14:42 |
| First problems with FTC and Labview | PhilBot | National Instruments LabVIEW and Data Acquisition | 0 | 10-09-2008 20:21 |
| Are Spikes needed with servos? | aksimhal | Electrical | 9 | 23-01-2007 20:27 |
Threaded Mode