|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#13
|
||||
|
||||
|
Re: The Trailer measurements
I am guessing you modeled based on an inscribed circle or circumscribed circle. Your dimension is probably correct based on that. The drawing for the team trailer panels utilizes an ordinate dimensioning scheme, and gives each point an X and Y dimension with the center being 0,0. The dimension given in the team drawing have the sides at 8 1/2". I think the field piece drawings give inscribed circle diameter.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attaching the Trailer | Eiske | Rules/Strategy | 6 | 04-01-2009 22:33 |
| Trailer Available for the Championship | OZ_341 | General Forum | 0 | 23-03-2008 07:25 |
| To Trailer or Not to Trailer? | Carol | General Forum | 14 | 25-06-2006 18:14 |
| Can you explain the diameter measurements used in bullets, wire and nails? | Morenoh149 | Technical Discussion | 3 | 28-08-2005 18:50 |