R08 Clarification

GaryVoshol · #1 06-01-2009, 13:17

And the wood is not allowed to extend past the corner of the frame.

Taylor · #2 06-01-2009, 14:52

Quote:

Originally Posted by GaryVoshol

And the wood is not allowed to extend past the corner of the frame.

Where did you find this? The only part I see is <R08>N which says the "Hard" part may extend a maximum of one inch from the BUMPER PERIMETER. I don't see anything about corners.

Edit: Happy Birthday!

Alan Anderson · #3 06-01-2009, 16:23

Quote:

Originally Posted by GaryVoshol

And the wood is not allowed to extend past the corner of the frame.

Quote:

Originally Posted by Taylor

Where did you find this? The only part I see is <R08>N which says the "Hard" part may extend a maximum of one inch from the BUMPER PERIMETER. I don't see anything about corners.

Try the next paragraph.

Quote:

Originally Posted by <R08>O

The BUMPER backing must not extend beyond the “edge” of the ROBOT. The backing of adjacent BUMPER segments must not attach to each other if the attachment would require that the joint extend into the corner (see Figure 8 – 4).

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Does <R08> prohibit above-bumper extension?	BethMo	Rules/Strategy	12	07-01-2009 09:20
IR Board Clarification	Pavan Dave	Rules/Strategy	3	06-01-2008 20:31
Clarification on Pinning	Stu Bloom	Rules/Strategy	2	15-03-2006 05:07
Rule <R08>, weight of upgrade parts	Gary Dillard	Rules/Strategy	6	11-02-2005 11:16
Rules Clarification	archiver	2000	1	24-06-2002 00:28