|
|
|
 FRC is a game of mentors. The best teams are guided by mentors who know how to balance on the knife edge of pushing the envelope and achieving success. - Mr. Van [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: DS Voltage reads 00.00V
Welcome to CD!
This question has been asked multiple times and answered both here and on FIRST Forums at forums.usfirst.com please search before you post. anyways you have to put a jumper on the analog break out on slot 1(closes to the Ethernet ports) on the cRio the jumper goes on the 3 pin connector separated from the rest of the connectors and th jumper connect the 2 pins closest to the outer edge of the cRio |
|
#2
06-01-2009, 19:45
|
|||
|
|||
|
Re: DS Voltage reads 00.00V
@both: Thanks, I'll look in the manual and give it a shot.
@0705920: Perhaps you didn't read my entire post, I did look all over this forum and couldn't find any solution, but thank you for pointing out that USFirst has its own forums. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pin voltage | tseres | Programming | 2 | 13-01-2008 14:30 |
| pic: Dez Reads HIGHLIGHTS! | Joe Matt | Chit-Chat | 8 | 26-05-2006 11:40 |
| OI Voltage | JAH | Electrical | 7 | 12-11-2004 20:01 |
| Who reads Slashdot? | Max Lobovsky | IT / Communications | 31 | 27-03-2004 00:07 |
| Voltage Byte -> True Voltage | Ulibrium | Technical Discussion | 11 | 01-03-2002 08:55 |
Hybrid Mode
