|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
|
|||
|
|||
|
Re: We NEED 8-inch wheels and programming help
Posted by Joe at 2/9/2001 5:09 PM EST
Student on team #506 from St. Anthony's HS. In Reply to: We NEED 8-inch wheels and programming help Posted by Dan Rich on 2/8/2001 4:34 PM EST: : Hey everybody. I'm from Team 550 in NJ, and we need a couple more 8 inch wheels. Anybody know where to get them? We would also like some help in getting two motors seperately controlled by one controller, one on the x-axis and one on the y-axis. Thanks. PWM port # what controlls it 1 joystick 1 y_axis 2 joystick 2 y_axis 3 joystick 3 y_axis 4 joystick 4 y_axis 5 joystick 1 x_axis 6 joystick 2 x_axis 7 joystick 3 x_axis 8 joystick 4 x_axis 9 joystick 1 wheel 10 joystick 2 wheel 11 joystick 3 wheel 12 joystick 4 wheel hope this helps. someone correct me if i'm wrong |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how does crab drive work? | Soukup | Technical Discussion | 13 | 25-04-2003 11:31 |