|
|
|
 FIRST isn't about the money. It is about the experience. - dubious elise [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST isn't about the money. It is about the experience. - dubious elise [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Benchtest Jumper Question
In section 3.4.1.2 of the Control System datasheets, where should the jumper be placed for the benchmark test? I am referring to the power selection jumper on the analog breakout module.
|
|
#2
07-01-2009, 23:09
|
|||||
|
|||||
|
Re: Benchtest Jumper Question
The jumper on the Analog Bumper in Slot 1 goes on the middle and outer pins. In the diagram in section 3.4.1.2 jumper the two pins at the very top of the diagram together. This pipes the 12v robot battery voltage into analog input #8 and the default (not OTB) code displays the battery voltage on the Driver Station.
The jumper on the Analog Bumper in Slot 2 goes on the middle and inner pins, so you can use that analog input #8 as a normal input. Last edited by Mark McLeod : 07-01-2009 at 23:12.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can i still benchtest without OTB version? | programmr | FRC Control System | 7 | 16-12-2008 20:52 |
| Ordering a center jumper | BQuennell | Electrical | 3 | 27-02-2007 15:08 |
| PWM 2 pin jumper | mechanicalbrain | Electrical | 4 | 18-12-2005 18:09 |
| Brake/Coast Jumper | archiver | 2001 | 3 | 24-06-2002 01:04 |
| broken jumper on controller | Mike Soukup | Technical Discussion | 5 | 22-10-2001 20:49 |
Linear Mode
