|
Re: SMALL Parts Hubs
Posted by Bob Drexel at 2/10/2001 8:59 PM EST
Engineer on team #358, Titans, from Hauppauge and Festo Corp..
In Reply to: SMALL Parts Hubs
Posted by Tyson Wormus on 2/8/2001 11:35 PM EST:
We had a problem with the hubs to. There seems to be a compatibility problem with the polymer and locktite (thread locker). I don’t know if you used any when assembling the wheels, but it will definitely cause the hubs to fragment if they come in contact with it.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|