steel plate ........legal dimensions?

Besides, you know hard it is to solder with gloves on? - Al Skierkiewicz [more]

		Chief Delphi > Old Forum Archives > 2001
steel plate ........legal dimensions?

Thread Tools

Rate Thread

Display Modes

24-06-2002, 00:32

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

steel plate ........legal dimensions?

Posted by S. Krussell at 2/9/2001 12:02 PM EST

Coach on team #349, Robahamas, from International Academy and Ford Motor Co..

Hey....we noticed that the additional hardware list has a 1/4 inch limit on steel plate, but that Small Parts has 3/8 inch available. So, the question is, can we use the 3/8 steel plate? I'm not sure if we can assume that we are allowed to use EVERYTHING/ANYTHING listed in the Small Parts catalog.

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gearbox	Lord Nerdlinger	Motors	20	15-07-2003 00:38
Pulling robot off ramp legal?	archiver	2000	2	24-06-2002 00:14
Update #5 is out	archiver	2001	1	23-06-2002 23:37
Legality of steel tubing.	newy	Rules/Strategy	3	01-02-2002 09:16
Field and shelf missing dimensions	kmcclary	Off-Season Events	3	12-10-2001 18:21

All times are GMT -5. The time now is 11:02.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.