|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
Re: Question about Bearings?
Not necessary, but HIGHLY recommended. The steel shaft would quickly open up the hole in the aluminum plate, then things just get worse from there.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| question about actuators | pollyproof12 | Technical Discussion | 6 | 11-11-2008 16:59 |
| A question about Eminem | robot180 | Chit-Chat | 64 | 23-04-2007 00:20 |
| Question about treads? | HarryV | Technical Discussion | 1 | 15-03-2005 12:53 |
| A little tip about those drill transmissions and bearings | archiver | 2001 | 6 | 24-06-2002 00:22 |
| Question about scoring.... | Katie Reynolds | Rules/Strategy | 2 | 06-01-2002 10:37 |