|
Re: operator interface board
Posted by Khalid at 2/13/2001 10:37 PM EST
Student on team #486, The Positronic Panthers, from Strath Haven High School.
In Reply to: operator interface board
Posted by Stephen on 2/9/2001 5:08 PM EST:
We have a very simple system. We use a 1' x 3' sheet of plywood. We needed no clamps. We bolted the OI and used velcro to attach the rest of the joysticks, radio(when not at the competition), and button panel. It worked fine for us.
: Does anyone have any good idead for setting up all the equipment for the operator interface board. The system last year was too wide, so we had to use c-clamps; so we specifically want ideas that conform to the 1 foot by 3 foot specifications.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|