|
|
|
 If it's the loss of American lives that concerns the nation, why not campaign aggressively against smoking, or improve automobile safety? At least then, the benefits will be tangible, and substantially more significant to the well being of the locals. - Tristan Lall [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#2
08-01-2009, 23:22
|
||||
|
||||
|
Re: Assembly of the AndyMark gearbox in Pro/E?
I've always converted the STEP files (from the AndyMark website) to a Pro/E format, and used that. It's just too much effort to rebuild the model, especially when I don't have a full set of drawings to work with.
Which AndyMark gearbox were you thinking of? (They sell many types.) I believe that I've got the Super Shifter and Toughbox models in Wildfire 3.0 educational format, if you're interested. There aren't any nice features like colours or material properties, but geometrically, they're equivalent to the STEP files. On the other hand, it's a good exercise to figure out how to convert file types and make nice, clean assemblies from imported STEP data using Pro/E. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AndyMark CIM Planetary Gearbox Torque Specs Needed | KTorak | Technical Discussion | 4 | 17-01-2008 18:53 |
| AndyMark - Super Shifter gearbox logo design contest | Andy Baker | General Forum | 85 | 16-07-2007 21:09 |
| 254/968 Gearbox Assembly Time Study/Analysis | Travis Covington | Technical Discussion | 8 | 08-05-2007 13:40 |
| pic: Vector Image Project - AndyMark Gearbox | Ryan Dognaux | Extra Discussion | 1 | 06-04-2007 15:43 |
| pic: Reworked AndyMark Gearbox | Mark Jones | Robot Showcase | 17 | 07-12-2005 22:53 |
Threaded Mode