Wind River Printing from cRio

[slavik262]

First, your cRIO must be on and properly connected to your computer through the driver station.

You must first then connect with the cRIO, right clicking on the VxWorks target and clicking "connect to target," assuming you have configured it properly as instructed in the C/C++ programming guide (the instructions I am referring to start on page 86). It should be in the menu on the bottom-left of your screen in the "Remote Systems" tab. Once connected, right click on the "Wind River Target Debugger," go to "Target Tools", and select "Target Console." If a configuration window appears, click ok, and you should now be connected to the console.

[nathanww]

The other thing to remember is that the "console out" switch on the cRIO must be set to "on" and the system rebooted before it will send output to the serial port

[virtuald]

Originally Posted by slavik262

Once connected, right click on the "Wind River Target Debugger," go to "Target Tools", and select "Target Console." If a configuration window appears, click ok, and you should now be connected to the console.

Theres also an option in the debug target options to immediately launch a console on debug. Quite useful.

[comwiz7]

I have followed all instructions and I haven't been able to receive any feedback from the cRio.

[360skier]

Are you opening the VxWorks console or using the serial port output?