|
|
|
 "Greatness isn't achieved by doing the uncommon things but instead by doing the common things uncommonly well."
- Wayne C. [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "Greatness isn't achieved by doing the uncommon things but instead by doing the common things uncommonly well."
- Wayne C. [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Do we have to update firmware?
Same place.
The cRIO image V7 comes as part of the "LabVIEW FRC software update" -- LabVIEW Update 2 When you install, the update V7 appears in the FRC cRIO Imaging Tool choices. Last edited by Mark McLeod : 09-01-2009 at 17:40. 
|
|
#2
09-01-2009, 18:34
|
||||
|
||||
|
Re: Do we have to update firmware?
okay so we have managed to find v7 but still have a problem. the imaging tool starts off okay but after 40 seconds or so it says "The specified IP address is unreachable. Ensure that the IP address is on the correct subnet."
Thanks for your help!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| driver station firmware update | bobbyt14 | Programming | 15 | 14-02-2009 15:05 |
| Driver Station firmware update failure | ofshea | FRC Control System | 8 | 13-01-2009 11:35 |
| Firmware update | Cuog | Programming | 2 | 21-02-2006 20:28 |
| Camera doesn't have firmware? no programming? | GraphicArtDesig | Programming | 6 | 19-01-2006 20:10 |
| Team Update #13: Where's The Firmware? | Astronouth7303 | Programming | 0 | 24-02-2004 19:25 |
Hybrid Mode
