|
|
|
 If I can do it, it's not art. - Ether [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If I can do it, it's not art. - Ether [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
cRIO Problem
Ok, I'm sure this question has been asked multiple times on other forum threads, but my patience grows thin
 so I will just go ahead and state my error. In LabView when we try to deploy a project to the controller, LabView says that it has failed to connect to a real-time connected to a real-time target. We have the correct ip address assigned to the controller but it won't connect, the battery is good but the status light is yellow. could that be part of our problem? Please help us as this is going to be extremely important to have a working robot this year  Thanks 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CRIO Error 60 | seanl | FRC Control System | 14 | 18-01-2009 16:29 |
| cRIO fuse??? 20 or 30? | mynameisbob | Electrical | 12 | 09-01-2009 11:33 |
| cRIO feedback | Maxpower57 | C/C++ | 2 | 08-01-2009 19:06 |
| cRIO plugin problem | gabrielse | National Instruments LabVIEW and Data Acquisition | 3 | 18-12-2008 11:30 |
| cRIO test drive *OFB* problem.... | NetSkay | FRC Control System | 5 | 10-12-2008 18:32 |
Threaded Mode