Wireless Connection Problem

[Mike Wittman]

We were a beta test team. We had this problem with the beta equipment and with our FIRST equipment. The simple answer is after you set up your network ip addresses power cycle everything in order. I don't know why but sometimes the IP address doesn't take until you power cycle the router and bridge.

This is the power cycle order
1 Router
2 Driver station (wait until it boots up) then go to step 3
3 cRIO
4 power up the wireless bridge

If powercycling doesn't work it is far quicker to reset the router and bridge back to factory default and start over rather than to try to figure out where you went awry. When you reset to factory default use the included disks do not do it from the web.