|
|
|
 Don't worry so much about the wording of the rules but the intent of the rules. - Greg Needel [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't worry so much about the wording of the rules but the intent of the rules. - Greg Needel [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Drive Station Holder - What do you use?
Hi all,
Not sure if anyone else noticed the driver station looks a bit better when it is angled up rather than just laying flat on a a table. When we were doing the bench test, I noticed that the station fit nicely into this little piece of plastic that was laying around dad's office. No idea what it is, but it fits QUITE nicely. What do you use? -Tanner 
|
|
#2
10-01-2009, 00:35
|
||||
|
||||
|
Re: Drive Station Holder - What do you use?
I think we are just going to velcro it down flat. I don't see why we need to angle it, you can't change the data displayed on the screen. Need to figure the best place to put feedback LEDs. Drivers tend to not look down.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What language do you use? | 1strobotixrox | Programming | 54 | 29-01-2007 02:18 |
| What sensors do you use? | StevenB | Programming | 18 | 06-04-2006 23:33 |
| What motors do you use to drive your robot? | _GP_ | General Forum | 25 | 25-01-2004 21:14 |
| What do you YOU use your bins for? | AlbertW | General Forum | 40 | 13-04-2003 04:18 |
| Which Drive Train Will you use? | Rick | Rules/Strategy | 3 | 07-01-2002 21:49 |
Linear Mode
