|
|
|
 The toughest regional that matters is the one you're in! - pfreivald [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The toughest regional that matters is the one you're in! - pfreivald [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Axis Camera responding in the Vision Assistant but not in WindRiver
When we connect the camera directly to the computer with a crossover cable (and set the computer's IP to 192.168.0.6), we can open up the NI Vision Assistant, set the Axis' IP as 192.168.0.90, and acquire photos.
When we connect the camera to port 2 on the cRIO (and change the computer's IP back to 10.xx.yy.6 and connect all the cables properly), we can "see" the camera image by running LabVIEW, but we can't connect using the NI Vision Assistant no matter what IP we try for the Axis. I guess this just means that, to use the Vision Assistant, you have to connect the camera directly? 
|
|
#2
11-01-2009, 12:50
|
|||||
|
|||||
|
Re: Axis Camera responding in the Vision Assistant but not in WindRiver
Yes, the Vision assistant will only work directly with the camera while it's connected to your PC.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with the Axis Camera | popo308 | FRC Control System | 16 | 15-01-2009 19:38 |
| Focusing the AXIS camera in LV | Bryan Herbst | Programming | 3 | 03-01-2009 23:21 |
| Camera will track one light, but not two? | Kevin Watson | Programming | 2 | 01-02-2007 22:34 |
| Camera did not work for well at the regionals, but worked great at home. | Alan Ing | Programming | 12 | 17-04-2006 17:43 |
| Camera Not Responding To Code | itzrobz | Programming | 2 | 05-02-2006 12:47 |
Hybrid Mode
