Problem with vision assistant

Luke Pike · #1 11-01-2009, 19:39

If you don't have an image in, then you probably didn't export the vi right. When you export, you need to select "Image Control" instead of "Image File" when you are asked to select an image source. If you did that, then you should have an image in and image out that you can wire up when you add it to the vision processing vi.

Bryan Herbst · #2 11-01-2009, 21:48

Ahh, that would be the problem.

Thanks!

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Axis Camera responding in the Vision Assistant but not in WindRiver	DanDon	C/C++	3	11-01-2009 12:50
Assistance in Vision Assistant	Carmelulu`	NI LabVIEW	1	10-01-2009 15:36
stereo vision system with OV7620	steveg	Programming	3	04-05-2006 12:40
Problem with communicating with STAMP through serial port	Skabana159	Technical Discussion	2	06-02-2003 21:10
BuzzWriter - PBasic Assistant	archiver	2000	0	23-06-2002 22:58