pic: Chassis Driving 2

[TD78]

Originally Posted by Elgin Clock

Just as an FYI, you may want to check your width of your robot.

The C-Chassis is assembled in a way in that picture that I believe may be too wide.

Basically what I'm trying to get at, is you may need to move the shorter channels that are bracing the wheels inward towards the center of the chassis to be within the required width requirement.

Other than that, it looks like a good start!

I would double check that statement. I was looking at the CAD model off the AM website last night and that is how it is assembled. I did a double take too, but Solidworks says it's within the allowable 38".

Actually, I'm somewhat curious how accurate the model is, because the depth is only 26.5". We haven't started cutting ours yet, so I don't know if that what you get when you go widebody, but I'm kinda curious...