|
Pneumatics Help!
Posted by Elaine at 2/12/2001 9:01 PM EST
Student on team #368, Kika Mana, from Mckinley High School and NASA Ames/Hawaiian Electric /Weinberg Foundation.
Hi, I was wondering if any of the teams out there could help us. Our question is that in the pneumatics manual under flow controls, it says that you always mount a flow control into the porst of the cylinders before you hook up the tubing. But in team update number three, it says that you can only use the pneumatics that are given to us in the kit with exception to the cylinders. Our question is... since only six flow control valves are given to us, how are we suppose to hook up four or more cylinders to our robot. Right now we are using two flow controls per cylinder, one on each side... are we suppose to use only one?
Elaine
Kika Mana
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
The real question is not whether any teams have had metal in a speed controller, it's whether any teams haven't. - EricH [more] 
Similar Threads
Threaded Mode