Pot Gyro - Chief Delphi

24-06-2002, 00:47

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Pot Gyro

Posted by Jason294 at 2/13/2001 11:36 AM EST

Other on team #294, Beach Cities Robotics, from Mira Costa and Redondo Union and TRW.

Just wondering if anyone had fooled around with this idea. I attached about a 4 inch long piece of aluminum bar with a small weight on the end to a pot and used the feed back as a good gyro that dosent tax the robot controller like the quartz gyro with the kit. Anyone working on differant algorithims to auto-balance the ramp... I know im close, just wondering if you guys had thought of this. I'm sure it will be helpfull to someone. If u want to contact me e-mail Jason@DigitalAftertime.com

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
gyro code	odin892	Programming	2	08-04-2003 14:50
Help with the gyro chip	Team852	Electrical	1	10-01-2003 22:31
This Gyro is driving me crazy!	archiver	2001	2	23-06-2002 23:35
Is any team using the gyro chip?	Ragin_Kage	Kit & Additional Hardware	4	10-04-2002 12:11
Have YOU used the gyro chip?	FotoPlasma	Technical Discussion	10	31-01-2002 13:26

All times are GMT -5. The time now is 01:18.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.