|
|
|
 Aw... am I too late to suggest a water game? - jgannon [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Aw... am I too late to suggest a water game? - jgannon [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Anyway to do a soft/quick reset to access a newly uploaded program faster?
I have a couple of questions in regards to the resets that are required to run a program just uploaded to the robot's control panel. Our team is using the 2009 kitbot parts and WindRiver/C++, if that's important to the reset process.
1) Does the robot itself have to be turned off then back on (or can I leave it on and just reset the control panel?) 2) Is there a better/faster way to reset the control panel than simply unplugging and replugging the A/C adapter? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RC remote program and reset button schematic | Bluephlame | Electrical | 5 | 10-02-2008 01:24 |
| FRC: Reset and Program Controls | yanksrock777 | General Forum | 4 | 24-01-2007 22:37 |
| Program error after controller reset | randomperson | Programming | 6 | 04-01-2005 23:31 |
| Robot Reset Under Program Control? | Dan | Programming | 5 | 29-04-2003 19:49 |
| How Do I Program My RC To Spot One wheel From Going faster than the other | Kyle1010 | Programming | 5 | 12-01-2003 15:30 |
Threaded Mode