Network Setup Problem

[aoconnor]

We followed the networking instructions in the FRC manual to setup the Robot Bridge and Router. After changing the settings on both devices and a laptop, we are able to connect to the router, but not the bridge.
Our laptop doesn't have an N-adapter, so are connected to the router (via DS) by a wired connection. We've also tried connecting the laptop directly to the router.
When we tried reconnecting an ethernet cable between bridge and router, we get an IP address conflict notice on the computer. We think this is because the bridge is connecting through wireless and wired with same IP address.
Any thoughts? There is some ambiguity in the manual about where the router should start allocating dynamic addresses, (the screenshot says 10.XX.YY.1, but the text says 10.XX.YY.10). We tried both, and think 10 is correct, but not sure if this has anything to do with the problem

Thanks!