Matching Drill Motors and Fischer-Price Motors

I wouldn't recommend using steel because it will eat up your weight budget pretty quickly. - Scott Morgan [more]

		Chief Delphi > Old Forum Archives > 2001
Matching Drill Motors and Fischer-Price Motors

Thread Tools

Rate Thread

Display Modes

24-06-2002, 00:51

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

How hot do the FP motors get?

Posted by Tim Gates at 2/15/2001 10:23 PM EST

Engineer on team #288, RoboDawgs, from Grandville High School and X-Rite/Delphi.

In Reply to: We're using both motors also
Posted by Andy Baker on 2/14/2001 10:15 AM EST:

With a 1:1 ratio, how hot are the FP motors getting after a couple minutes of running up and down the ramp? I'm always looking for a better way.

Tim Gates

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fischer Price Motor help needed	archiver	2000	10	23-06-2002 22:07
Fischer Price Part Number?	bmusser	Technical Discussion	0	02-02-2002 12:26
fischer price motors	Paul Marshall	Motors	4	12-10-2001 09:44

All times are GMT -5. The time now is 22:23.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.