|
|
|
 Maybe this thread should be re-titled "Waiting impatiently for the 2011 hint!" since having over 100 posts doesn't seem very patient. - Joe Ross [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Maybe this thread should be re-titled "Waiting impatiently for the 2011 hint!" since having over 100 posts doesn't seem very patient. - Joe Ross [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
14-01-2009, 23:42
|
|||||
|
|||||
|
Re: Driver Station Update
The dongle problem is probably just a fault in that little switch on it.
If you have a multi-meter try testing the pins while you flip the switch to see if it's operating properly. The motors not running is probably a separate problem. How far did you get in your setup? Did you bench test the control system? After that did you reflash the cRIO and the Driver Station? Were you able to set your team number on the DS? Is your DS plugged directly into the cRIO with an ethernet cable or are you using the wireless? Has the wireless router/bridge been setup? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| driver station firmware update | bobbyt14 | Programming | 15 | 14-02-2009 15:05 |
| Driver Station firmware update failure | ofshea | FRC Control System | 8 | 13-01-2009 11:35 |
| 2nd Driver Station | bcharbonneau | General Forum | 2 | 09-01-2009 14:19 |
| Driver Station Help.. | 1708xMr.Roboto | FRC Control System | 8 | 22-12-2008 15:24 |
| Driver Station Setup?? | Team 1708 Dave | Programming | 9 | 19-12-2008 23:09 |
Threaded Mode