servo Twiching in Labview

[Sykan]

Hello, i've been working with labview and i open a new advanced project and trying to get my camera to track with servos. but when i loaded the code the servos just twiched in place when i viewed the get angle function it twiched between 0-85. i can't help to think i put the open servo and close servo in the wrong place. in the teleop i put the open servo to the left of the case which is connected to the get/set angle inside of the execute function and the close on the right side of the case. Did i set this up wrong?

Thanks.

David Elizondo
(Programmer)