|
|
|
 You cannot change people, you can only change yourself. - KenWittlief [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| You cannot change people, you can only change yourself. - KenWittlief [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
|
Re: Problems with the Axis Camera
My team cannot access the camera when it is plugged into the cRIO. We think it is ethernet port #2 that we actually cannot access.
 We cannot seem to figure out how to enable the port.
|
|
#17
15-01-2009, 19:38
|
|||||
|
|||||
|
Re: Problems with the Axis Camera
You aren't trying to access the camera from your PC are you?
The camera isn't accessible from your PC when it's plugged into the cRIO. The network addresses aren't compatible. The camera can only be accessed from a program running on the cRIO itself. Just making sure what you're talking about...
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axis camera without the cRIO | CrazyCarl461 | NI LabVIEW | 12 | 17-01-2009 10:53 |
| PROBLEMS WITH THE CAMERA | RDD | Programming | 2 | 18-02-2007 15:12 |
| Please help me with my Camera problems! | Ianuser | Programming | 2 | 10-02-2007 21:17 |
| again, problems with the camera | razer | Programming | 4 | 02-02-2007 11:50 |
| problems mounting the camera to the 'bot with the default servo/mount set up | Redneck | Programming | 0 | 16-02-2005 20:53 |
Linear Mode
