|
Hot Off The Mill And Ready For Action!
Posted by Ed Sparks at 2/14/2001 9:04 PM EST
Engineer on team #34, The Rockets, from Bob Jones High / New Century High and DaimlerChrysler.
Actually we used a similar wheel last year and attracted a lot of attention from the FIRST officials but we were never told to remove them. The funny thing is that these wheels don't actually cut the carpet loops but they do "comb" the loops if you continue to spin the wheels when held in a fixed position. Does anyone have any experience with carpet "combing" as far as the "carpet damage" rules go?
PS
Yes I have alternate wheels just in case and yes I drive our machine shop guys a little crazy......
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
The math isn't that hard. It's just a tool, like a screwdriver or soldering iron. Sure you get tired of picking up the same old thing everyday, but when you have to tighten a screw you still reach for the screwdriver. - Al Skierkiewicz [more] 
Threaded Mode