2007 Controller Power cable?

JamesByrne · #1 15-01-2009, 23:02

If you are talking about the crio you need to supply your own cable, look at the first electrical diagram

If you are talking about the drivers station you need to use the supplied adapter. Let us know what you are talking about.

Vikesrock · #2 15-01-2009, 23:07

Quote:

Originally Posted by JamesByrne

If you are talking about the crio you need to supply your own cable, look at the first electrical diagram

If you are talking about the drivers station you need to use the supplied adapter. Let us know what you are talking about.

He said 2007. I believe he meant the OI for the IFI control system. I don't have the specs for this supply at the moment, but hopefully someone else will be able to help you out.

JamesByrne · #3 15-01-2009, 23:10

ok sorry im tired

i should have read better. ya i do not have this handy either. But i can look it up tomorrow for you.

Justin Stiltner · #4 15-01-2009, 23:11

Should be the same as the one in this thread
http://www.chiefdelphi.com/forums/showthread.php?t=48364&highlight=operator+interfac e+power+supply

your looking for a wall wart power transformer, there is a photo in the thread showing the label

RyanN · #5 15-01-2009, 23:48

I believe they were 9V 1500ma. Center pin positive.

Andy L · #6 16-01-2009, 00:52

I'm not in our shop right now, so I can't be sure, I think it says EVERGLOW in big letters on it

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
controller power question	Spiders	Control System	2	13-02-2008 13:11
2007 tether and program cable question	Japper	Control System	11	08-05-2007 20:55
Servo Controller Power Issues....	John Gutmann	Electrical	8	09-04-2007 01:31
Amount of power drawn by FRC controller?	Teger	Electrical	6	08-01-2007 17:39
Camera power cable	MustangRobotics	General Forum	11	12-01-2006 22:39