|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#11
|
|||||
|
|||||
|
Re: Precision Ground 1/2" 7075 Rod Supplier
Not knowing your design I cannot say for sure, but some things to think of...
#1 really think about your design, can you use normal 1/2" round bar and just turn the ends down where the bearings are to size? Further do you really need 7075? 6061 does pretty good for most uses. #2 that much AL weighs about 50LBS Could you turn tube down to the proper size?You may try igus, they make AL shafting meant to fit their plastic bearings (they work really well) website here http://www.igus.com/drylins.asp They list their shafting as .5 however I couldn't find true dimensions. They have a really nice program where you can get their stuff for free for school projects, they just ask you send them a photo and a writeup of what you did with it. Good luck |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| reducing sensativity of joystick for precision? | windell747 | Programming | 8 | 18-02-2008 10:15 |
| Precision of Shooting | Nitroxextreme | Robot Showcase | 0 | 10-02-2006 07:39 |
| Shooter Precision poll | NullTerminator | Rules/Strategy | 9 | 09-02-2006 23:23 |
| supplier for 5/8" shaft | david.clark | Kit & Additional Hardware | 2 | 17-01-2004 18:13 |
| Goal Drawings Precision | petrrj | OCCRA | 1 | 23-09-2003 21:01 |