|
|
|
Picking up tetra's is going to be as easy as picking up a person of the opposite sex.
While a select few will master it; others will be bumbling maroons..
- Elgin Clock [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
How to program relay in labVIEW?
Hello, we're from team number #2576 from Chile, we want to programing the relays with 2 of the joystick's buttons.
We tried everything what we find but, we don't know how to do it so please help us 
|
|
#2
16-01-2009, 13:36
|
|||
|
|||
|
Re: How to program relay in labVIEW?
Check under ACTUATORS in the WPI Robotics Library.
Keep in mind that they may not say "Relay" even if that's what they'll end up using. The LabVIEW code tends to take care of a lot of things behind the scenes. I'll see what I can find when I get into the shop later. As far as using Button 2 of the Joystick, use the Joystick GET VI and wire the Buttons output to an "Unbundle by Name". This will allow you to access Button 2.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do you program joystick buttons in LabVIEW? | darkpheonix | NI LabVIEW | 10 | 13-04-2014 10:20 |
| Making the Labview program stick | CDlabrador | National Instruments LabVIEW and Data Acquisition | 3 | 13-01-2009 20:19 |
| Help to Deploy a Program in Labview. | Delian | NI LabVIEW | 7 | 10-12-2008 21:13 |
| Relay program? | team877 | Programming | 11 | 04-02-2008 11:11 |
| How to conect solenoids to the circuit board. and how to program it...??? | arpitshah | Pneumatics | 6 | 13-01-2008 15:06 |
Hybrid Mode
