|
|
|
Picking up tetra's is going to be as easy as picking up a person of the opposite sex.
While a select few will master it; others will be bumbling maroons..
- Elgin Clock [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#2
16-01-2009, 14:34
|
||||
|
||||
|
Re: Servos, DSC and labview
Yes. First, you need to put a jumper on the pins next to the PWM ports you want to use for servos. Next, use the open/get/set servo vi's in LabVIEW to operate them.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview Servos | quizbiz | NI LabVIEW | 5 | 09-01-2009 08:48 |
| Working with spikes and servos in labview | EROCK | Technical Discussion | 2 | 07-01-2009 11:38 |
| Labview NXT Servos | quizbiz | National Instruments LabVIEW and Data Acquisition | 1 | 30-12-2008 14:42 |
| Rack and Pinion/Motors and servos | psniffler | Motors | 7 | 25-01-2008 16:16 |
| servos and the camera | incognito_NICK | Programming | 5 | 09-02-2005 00:00 |
Linear Mode
