|
|
|
 Stop. Breathe. Relax. QUIT STATING STUFF THAT YOU DON'T KNOW TO BE TRUE.
- Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Stop. Breathe. Relax. QUIT STATING STUFF THAT YOU DON'T KNOW TO BE TRUE.
- Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
17-01-2009, 11:24
|
|||||
|
|||||
|
Re: [FTC]: Help requested, the NXT is not showing the battery as being connected.
Also check to make sure that your motor controller is plugged into Sensor Port 1 on the NXT. If you are using ROBOTC, download the latest version (1.46 as of now). One last thing to do is to scan the forums on www.robotc.net. I recall seeing some discussions about low voltage and other issues with the 12VDC battery earlier in the season.
Good luck 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| paper: Reading the FTC Battery Voltage | PhilBot | Extra Discussion | 4 | 16-01-2009 08:46 |
| [FTC]: Reading the 12V Battery voltage in LabVIEW | PhilBot | FIRST Tech Challenge | 7 | 12-01-2009 21:13 |
| Lie down the battery or not?! | Nadav Gross | Technical Discussion | 8 | 03-02-2007 22:26 |
| CMUCam Forum messages are not being poseted as recent activity in the portal | Bob22341 | CD Forum Support | 3 | 31-01-2007 22:34 |
| Anyone concerned about the possibility of not being allowed to go to Nationals? | skrussel | Championship Event | 41 | 03-04-2003 11:35 |
Threaded Mode