Gearbox Brace & Bracket models?

[Gary Dillard]

Does anyone have a step file of the Gearbox Brace (PN am-0203) or the Gearbox Bracket (PN am-0204)? They are not in the step file of either the toughbox or the C-Base assemblies on AndyMark. Makes it kinda hard to assemble the gearboxes and the chassis together in a model without them.

[R.C.]

Andy said that the CAD will be uploaded later. I would make them, but the plates are angled and the holes are longated. I don't have a caliber at my house. So like yeah. Just have to wait. Sorry Homeslice.

[mplanchard]

Here is the brace cad model on www.3dcontentcentral.com. AM-0203 and AM-0204. The complete Chassis Long is there too. Download them in any format you wish, SolidWorks, Pro|E, Autocad, STEP. Data from AndyMark. Marie

http://www.3dcontentcentral.com/part...&catalogid=171

Here is the bracket
http://www.3dcontentcentral.com/part...&catalogid=171

[Gary Dillard]

Sweet! Thanks Marie - nice job

fyi - the bracket pn on your page says an instead of am; I don't know if that field is used in searches or not.

[mplanchard]

Thanks for the correction. I will make the partnumber change.

The complete Andy Mark Payload AM-0313 trailer has just been posted. I removed all internal brackets so that the model file size would be smaller. The 3d preview image only shows the bumper. The 2d preview shows top, front, right and isometric views - but the model file downloads fine in all 3d and 2d formats.

http://www.3dcontentcentral.com/part...&catalogid=171

If you are using SolidWorks, use mass properties in the assembly to add the weight of your trailer. AM should have that value. Also, use a Tangent mate on the wheels to the slick floor surface and a Concentric mate to the hole of the trailer channel bar where you put the pin to connect to the robot. That way you will see the rotation (swing) the trailer will have. Marie