|
|
|
 Paper is not so bad. It is really rare for it to crash or run out of battery, for example... - DonRotolo [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Paper is not so bad. It is really rare for it to crash or run out of battery, for example... - DonRotolo [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Program Wirelessly
I have had equal success just connecting my laptop to the wifi network and using DHCP. If you want, you can assign a static IP of 10.xx.yy.6 to the PC, but in our tests, this is not necessary.
Remember, there is nothing special about any of these ports.. Its just one big network.. |
|
#2
18-01-2009, 09:12
|
|||||
|
|||||
|
Re: Program Wirelessly
It is only necessary to set your PC to a static IP of .6 if you want to use it to receive dashboard packets from the cRIO.
Those dashboard packets are sent via UDP exclusively to 10.xx.yy.6. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cannot Connect to Axis Camera Wirelessly | computerish | Technical Discussion | 4 | 11-01-2009 19:19 |
| Can not connect bridge and router wirelessly | team877 | Programming | 4 | 08-01-2009 00:18 |
| Using an Operator Interface with the 2004 EDU RC wirelessly | Dave Flowerday | Robotics Education and Curriculum | 34 | 19-04-2004 19:06 |
| Need C Program! | IrOnMeN_883 | Programming | 4 | 14-02-2004 17:36 |
| VB program | archiver | 2000 | 0 | 24-06-2002 00:29 |
Hybrid Mode
