|
|
|
 It may not happen overnight, but in time if you keep focused and keep working hard, it will become a reality. - Michael Sperber [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It may not happen overnight, but in time if you keep focused and keep working hard, it will become a reality. - Michael Sperber [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Workbench is not working. Need help Please
We have been trying to get workbench installed so that we can start programming. We originally had problems with our licensing not working correctly. We now have the license working but after we installed workbench we dont have an executable to run workbench. We checked the start menu under national instruments and it was not there so we went through c:\windriver\workbench 3.0\ and there is no executable anywhere in this route. We also do not see any executable in route c:\program files\national instruments\ . We have tried uninstall and reinstalling and still no luck. We definitely installed workbench also. Inserted DVD 2 and ran through installation, also ran through updates from the FRC website.
Not sure if it helps but running on Vista as well. Any suggestions you have would be greatly appreciated. Thank you, Team 869 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Robot not doing what we need it to, and printfs aren't working | Bryan Herbst | Programming | 8 | 21-09-2008 20:58 |
| Need some help with arm not working... | neilcooper | Programming | 3 | 15-03-2008 06:16 |
| PLEASE HELP: OI switch box not working | RbtGal1351 | Control System | 2 | 18-02-2006 19:34 |
| reverse of motors NOT working please help | Stillen | Control System | 4 | 11-02-2006 22:05 |
| my comp is not working right and i need help | Timmyd | Chit-Chat | 17 | 07-11-2005 23:39 |
Threaded Mode