|
Re: Compacting the arms...
Posted by Matt Leese at 2/15/2001 11:01 PM EST
Other on team #73, Tigerbolt, from Edison Technical HS and Alstom & Fiber Technologies & RIT.
In Reply to: Re: Compacting the arms...
Posted by Tim Gates on 2/15/2001 10:57 PM EST:
Well, Schedule 40 PVC is strong, sometimes. It's much better at taking tension or compression forces than it is in taking lateral forces. So if you're trying to make an arm out of it with some sort of weight attached, it'd be much more likely to break. At this point I think your best bet is to just try different materials and see what works. One thing that you might try is electrical conduit but it does tend to be rather heavy (it's steel usually).
Matt
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
Turning is overrated - Allison [more] 
24-06-2002, 00:56
Similar Threads
Threaded Mode