|
|
|
 I'm gonna go back to my corner and write some more code... - Kevin Watson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm gonna go back to my corner and write some more code... - Kevin Watson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
18-01-2009, 17:27
|
||||
|
||||
|
Re: cRIO has no code
When you debug code of the robot it is not stored permanently, so when you reset it there is no user code. I'm guessing this is what happened.
Make sure that you've read and understand pages 20-26 of the C/C++ Programming Guide. You may be having a different issue, but without more detail about the error message I can't know. The battery voltage monitoring and reporting code is located in the WPILib code, so unless you're running a modified version then it should report a voltage. Even if you broke that part of the code it would report 0.0 volts not NO CODE. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Battery: No Code" after uploading .out file to cRIO | knine143 | FRC Control System | 1 | 20-12-2008 22:14 |
| cRIO - motor controller code (esp. victor) | ericand | Programming | 8 | 06-12-2008 22:09 |
| Team 166 Has Open Sourced Its Code | platypus | Programming | 13 | 09-02-2008 16:03 |
| Does anyone has code for accelerometer? | sjung9442 | Programming | 2 | 30-01-2006 21:37 |
| Has anyone craked the code yet | Jeremy | General Forum | 2 | 09-01-2004 14:12 |
Threaded Mode