Round Belting - Solid vs. Hollow, Polycord vs. McMaster

There is no right or wrong way to do this. - nuggetsyl [more]

		Chief Delphi > Technical > Technical Discussion
Round Belting - Solid vs. Hollow, Polycord vs. McMaster

Thread Tools

Rate Thread

Display Modes

#25

18-01-2009, 19:06

Bruceb

Registered User

FRC #0706 (Cyberhawks)

Team Role: Mentor

Join Date: Jan 2008

Rookie Year: 2004

Location: Merton, wi

Posts: 616

Re: Round Belting - Solid vs. Hollow, Polycord vs. McMaster

BTW.. I just got done making 10 belts from 1/4 round solid urethane(orange) belting 10 percent short. They are tight but running on half inch steel shafts 10 inches long and in bearings they seem fine.
Bruce

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Hollow Shaft optical encoders	magical hands	Control System	2	24-03-2005 09:12
Hollow Shaft optical encoders	magical hands	Robotics Education and Curriculum	0	03-02-2005 22:56
Polycord Belting	Claires4sorrow	Technical Discussion	1	31-01-2004 13:37
solid edge solid works	ceileachair	Inventor	1	21-01-2003 22:03
HELP! ChiefDelphi needs Green 1/4" polycord!	Brandon Martus	General Forum	1	14-03-2002 19:25

All times are GMT -5. The time now is 14:52.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.