|
|
|
 You heard it here first folks. The robot will definitely need wheels and will probably have an arm. - DampRobot [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You heard it here first folks. The robot will definitely need wheels and will probably have an arm. - DampRobot [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Mounting Sprockets to the Rover Wheels
Hey,
So I was mounting some AndyMark aluminum sprockets to the rover wheels and I noticed that the holes in the wheels are smaller than those in the sprockets. How have other teams been dealing with this? I ended up using machine screws that fit through the wheel mounting holes, but because they're smaller than the holes on the sprocket, it shifts around. Any suggestions? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Press release: Nypro makes the rover wheels! | Elgin Clock | Kit & Additional Hardware | 1 | 12-01-2009 12:01 |
| Rover Wheels | neoshaakti | Kit & Additional Hardware | 11 | 09-01-2009 14:34 |
| Cost of Rover Wheels | Boco Gear | General Forum | 3 | 08-01-2009 16:10 |
| Mounting two output sprockets on andyMark :confused: | EduardoVemny | Motors | 5 | 10-01-2008 21:37 |
| mounting the wheels | Stormhammer | Technical Discussion | 8 | 28-01-2005 14:41 |
Threaded Mode