Robot Controller & Operator Interface troubles

14-10-2001, 02:10

Matt Leese Matt Leese is offline

Been-In-FIRST-Too-Long

FRC #1438 (The Aztechs)

Team Role: Engineer

Join Date: May 2001

Rookie Year: 1998

Location: Long Beach, CA

Posts: 937

Matt Leese has a reputation beyond repute

Last year (ie 2001), we had problems with our robot controller and the cold. The controller would refuse to boot when it was too cold. The InnovationFIRST people diagnosed it as a bad solder joint and told us to replaces. As you're having the exact opposite problem, I doubt that's the problem but figured this might help in some way.

Matt

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How much planning goes into your robot?	Jnadke	General Forum	41	29-01-2006 21:29
serious problem found - robot controller resets when jarred!	KenWittlief	Electrical	23	19-03-2003 13:30
Controlling a FIRST robot with a Lego RCX Controller?	archiver	2001	5	24-06-2002 04:19
WASH Palm scouting at the Championship	Mike Soukup	Scouting	2	19-04-2002 15:14
about how Drive Train push the robot... shouldn't the force accelerate the robot?	Ken Leung	Technical Discussion	12	26-11-2001 09:39

All times are GMT -5. The time now is 05:35.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.